볼스크류의 큰 역오차는 높은 발생률에서 흔히 발생하는 문제입니다. 이 문제는 작업 진행에 심각한 영향을 미치고 작업 효율성을 크게 저하시킵니다. 이때 모든 기술자는 볼스크류의 공통적인 문제점과 해결방안을 파악하고 충격을 최대한 줄이는 것이 필요하다.
1. What is the reason for the large reverse error of the ball screw?
1. The pre-tightening force of the ball screw is too tight or too loose;
2, the screw shaft coupling taper sleeve is loose;
3. The pre-tightening force of the screw support bearing is too tight or too loose;
4, the screw shaft sliding plate cooperation wedge iron is too tight or too loose;
5. The ball screw has large manufacturing errors or axial movement;
6. the screw shaft slide plate cooperation pressure plate is too tight or too loose;
7. Other mechanical disturbances.
Two. How to remove the wrong direction of the ball screw:
1. Adjust the pre-tightening force and check the axial movement value, so that the error is not greater than 0.015mm;
2. Re-adjust or study from the beginning to make the contact rate reach more than 70 percent . If the 0.03mm feeler gauge is not used, it is qualified;
3. Re-adjust or study from scratch;
4. It is qualified if the 0.03mm feeler gauge does not enter;
5. Repair adjustments or padding;
6. repair and adjustment;
7. Adjust to the surface of each guide rail with lubricating oil;
8. Fasten from the beginning and use a percentage to indicate the repeat test;
9. Sweep away dry and parts.
볼스크류는 공작 기계에서{0} 가장 많이 사용되는 고정밀 전달 요소입니다. 고정밀{1}}특성은 머시닝 센터에 전례 없는{2}}고속 이송 특성을 제공합니다. 동시에 작업이 약간 부적절하면 단순히 더 많은 오류가 표시됩니다. 오류 분석.
GY는 완전한 범위의 레일과 너트를 제공합니다. 우리에게 선형 도전을 설정하지 않으시겠습니까?
